Instead of following a moving average, the structure analyses in Algo Signals look for highs, lows and levels where price has already reacted. This lesson explains what each one really computes. They are reading aids: none has a proven edge.
The foundation: pivots
Almost all of them rely on pivots. A swing high is a candle whose high is above the highs of the 3 candles on each side (default setting); a swing low is the opposite. A pivot is only confirmed 3 candles later, so the analysis does not “repaint” the past, but it always arrives late.
Structure and price zones
- Structure (structure): bullish after a break of structure, meaning a close above a previous swing high; bearish after a close below a previous swing low. Only the close counts, not the wick.
- Highs and lows (hhll): bullish if the last high is higher (HH), the last low is higher (HL) and price stays above that low; bearish for LH + LL; neutral if the structure is mixed or broken.
- Supports and resistances (sr): nearby pivots (within 0.15% by default) are grouped into zones touched at least 2 times. Price inside a support zone gives a bullish state (possible bounce), inside a resistance a bearish state.
- Turtle (turtle): the candle pokes its wick beyond the high (or low) of the previous 20 candles, then closes back inside. It is a false break: the signal points opposite to the break.
Value zones
- Fibonacci (fib): take the last leg, between the last two pivots. If price has pulled back between 38.2% and 78.6% of that leg, the state follows the leg’s direction (buy after an upward leg). Legs smaller than 1.5 ATR are ignored.
- Premium / Discount (premdisc): over the last 50 candles, compute the midpoint between the highest high and lowest low. Below the midpoint (5% of the range as margin) price is in “discount”: buyer state; above, in “premium”: seller state.
- Pivot points (pivots): levels computed from the high, low and close of the previous period (day or week). In CPR mode, a close above the top edge of the central zone is bullish, below the bottom edge bearish. In Camarilla mode, it looks at breaks of the H4/L4 levels or rejections of H3/L3.
When you also tick a trigger indicator (moving-average cross, MACD…), some of these analyses (structure, hhll, sr, fib) become filters: they no longer vote, but a buy is kept only if they are bullish and a sell only if they are bearish.
📝 Lesson test
Log in to take this lesson’s test. Once you have passed all the tests, you will receive a certificate in your name.
Log inThese lessons are for understanding and are not investment advice. No method guarantees winning.